Give Boost to Your Home Network with Netgear AC1200 Range Extender

 

Netgear AC1200 range extender is a type of wireless frequency repeater used to boost and amplify the reach of your wireless LAN. The range extender is placed in between your existing WiFi router and the WiFi-enabled device to receive the acceptable frequency service.

 

Netgear WiFi extenders are the most effective for WiFi devices that cannot access weak signals. With so many complicated oversees around you for Netgear extender setup, we will try to give our best shot to make you understand in a simple and easy manner. Just keep following the article till the end.

 

After purchasing the Netgear AC1200 extender, your next step is to actually install and place it in the right orientation. Placing in the wrong or bad physical manner is one of the main reasons behind the disconnect or dropping of Internet connection. So how to choose the best location for the range extender device. Let's check out.

 

Favorable Placement for Netgear Wi-Fi Range Extender

 

First of all, make sure that full WiFi range signals are available in-between your wireless extender and the main router. If the wireless network connection between your Wi-Fi extender and router is either slow or weak, then your speed is limited.

 

Now even if your Wi-Fi enabled devices have full bar connection to the Netgear AC1200 range extender but still you will lose network connectivity often.

 

If the network signals between your range extender to the router is not dropping and quite stable. It means your main router network signals are unstable and dropped parallel.

 

Now the next move is to find out the best location for your Netgear extender. So, to reach every dead zone corner around your residence. Plan that location where you spend the most time with your laptop, smartphone, etc. and then plan it out.

 

Netgear AC1200 range extender has the external antennae to help you out to reach dead network spots. Now after placing the extender device, it’s time to move a step ahead towards the installation and setup of Netgear extender.

 

How to Install Netgear AC1200 Extender using Web Browser?

 

1. Firstly, plug-in your Netgear extender into an electric power outlet and wait for the power LED to turn into the solid green.
2. Now with the help of my laptop try to connect to Netgear_EXT wireless SSID network.
3. You can also install your range extender by using Ethernet cable with your computer.
4. Once the desktop or laptop is connected with your range extender network the Device LED will become solid.
5. Now visit the web browser and go to mywifiext net setup page.
6. Tap on the Netgear Genie smart setup button.
7. Complete the extender setup procedure and tap on the Next button.
8. Select the WiFi network that you like to extend and then click on the Next button.
9. Enter the network security passphrase key and tap on Next.
10. Your Netgear AC1200 extender is now configured.
11. At last tap on the Finish button to complete the registration procedure.

 

Install Netgear AC1200 Extender using WI-Fi Protected Setup (WPS)

 

1. Firstly, press and hold the WPS button present on the Netgear extender for about 5 seconds. The WPS LED present on the front side will start blinking up.
2. Now within the next two minutes press the same WPS button present on the router.
3. Keep both the devices powered up for 10-15 minutes while the extender and router get sync with each other.
4. Once connected and sync successfully, unplug your range extender and place it in the midway of your router network range and dead network zone.

 

We hope that you have got all the information about Netgear AC1200 extender for what you are looking for. We tried to describe every point as easily as possible. If somehow you still tackle some issue related to Netgear WiFi extender device, feel free to share with us through comments.